Arduino case assembly

Arduino case assembly

I show this procedure on Arduino Mega, but the method is exactly the same with all Arduino cases (Mega, Due, Uno, Leonardo, ...)

1, Insert nylon spacers

2, Screw the board on base plate

3, Install metal spacers in the 4 corners.

Put the washer on the top of the acrylic sheet, it's important!

4, and then comes the metal spacer

5, Install 4 side parts

6, Put top part. Align side parts to match to top part.

7, There will be an approx. 0.5mm gap between metal spacer and top part. Slide washer here into this gap and then screw the bolt.

8, Ready :)